Operation Manual

Instruction manual ADMR 29

3.9.4 Fitting the flue gas sensor

Attached to the control column is a plastic bag containing the flue gas sensor

and related mounting components.

The sensor lead is already connected inside the control column, but not

Flue gas safety

Fit the flue gas sensor as follows:

1. Take the bracket (1) (with flue gas sensor (2) already fitted) from the

packaging.

2. Place the bracket in the draught diverter and screw the bracket firmly in

place.

3. Bend the cable clips (3) around the flue gas sensor lead.

4. Click the plug (4) of the sensor cable (5) into the flue gas sensor.

5. Screw the cable clips (3) tightly into the draught diverter and the

3.10 Electrical

connection

Warning

The installation should be carried out by an authorised installation engineer,

in compliance with general and local regulations (1.3 "Regulations").

3.10.1 Introduction

Topics covered in this paragraph:

•Preparation

;

• Connecting the mains power

;

• Connecting flue damper

Optionally, it is possible to connect an isolating transformer, a continuous pump,

a program-controlled pump, an extra ON mode switch and an extra alarm signal

to the appliance. For these options, see:

• Connecting an isolating transformer

;

• Connecting a continuous pump;

• Connecting top to bottom circulation pump

;

• Connecting an extra ON mode switch ("Tank ON")

;

• Connecting an extra error signal ("Alarm OUT").

Note

The optional components are not included in the rating for electrical power

consumption stated in the table (3.4.2 "General and electrical specifications").

Legend

1 bracket

2 flue gas sensor

3 fastening bracket

4plug

5 sensor lead

IMD-0120 R1