Operation Manual

Instruction manual ADMR 35

The display will now show

INTERNAL CHECK

for about 10 seconds and

go to the main menu.

8. Activate the "ON mode" by going through the following steps:

- Press the blue arrow once ( ) to position the cursor in front of

and

press . The display shown here will appear.

- Confirm the by pressing

START OPERATION

The appliance is now in the "ON mode" and will ignite.

9. When the display shows the text

RUNNING

, you must wait about 1 minute

before reading the dynamic pressures.

10. Use the pressure gauge to read the supply pressure at test nipple (6). Refer

to the gas data table (3.4.3 "Gas data")

Note

Consult the mains gas supply company if the supply pressure is not correct.

11. Use the pressure gauge to read the burner pressure at nipple (8). Refer to

the gas data table (3.4.3 "Gas data").

Note

If the burner pressure is incorrect and the appliance is fitted with a blank

plate or high-low control, then you cannot adjust the pressure. In this case,

consult your installation engineer or supplier. If the appliance is indeed fitted

with a burner pressure regulator, the pressure can be adjusted by following the

steps below.

INTERNAL CHECK

»OFF

^ ON

È WEEK PROGRAM

»START OPERATION

^ CHANGE SETPOINT

È Tset=65ÉC