Operation Manual

Starting and running
52 Instruction manual ADMR
9
gis
3. During the waiting time, the flue damper opens.
- The icon is activated.
- The message FLUE DAMPER appears.
4. After the flue damper opens, the text
GLOW PLUG
appears on the display. This is followed by the
(pre-)glow of the hot surface igniter.
- The icon is dimmed.
- The icon is activated.
5. After a number of seconds pre-glow, the gas
control is opened and ignition takes place.
- The icon is activated.
- The message
IGNITION appears.
6. After ignition, the flame is detected and the
appliance will be running. This means that actual
heating has started:
- The icon is dimmed.
- The icon is activated.
- The message RUNNING appears.
7. When the water reaches the set temperature, the
demand ceases. The flue damper and gas control
both close and the burner tray is extinguished. A
new waiting time of about 10 seconds starts.
- The icons , , and , are dimmed.
- The icon is activated.
- The message
WAITING TIME appears.
8. After the waiting time, the appliance enters an idle
state:
- The icon is dimmed.
- The message WAITING TIME disappears.
- With any subsequent heat demand, the
heating cycle will resume from step 1.
ON ÊÊÊ
13:45 Thursday 63ÉC
Tset 65ÉC
FLUE DAMPER
ON Ê Ê Ê
13:45 Thursday 63ÉC
Tset 65ÉC
GLOW PLUG
ON Ê Ê Ê Ê
13:45 Thursday 63ÉC
Tset 65ÉC
IGNITION
ON Ê Ê Ê Ê
13:45 Thursday 63ÉC
Tset 65ÉC
RUNNING
ON Ê Ê
13:45 Thursday 65ÉC
Tset 65ÉC
WAITING TIME
ON
14:05 Thursday 65ÉC