Water Heater Installation Manual

42 Page
Operang Safety
Owner's Guide
OPERATING SAFETY
WARNING:
If you do not follow these instructions exactly, a re or explosion may result
causing property damage, personal injury or loss of life.
A. This appliance does not have a pilot. It is equipped with an ignition device which automatically
lights the burner. Do not try to light the burner by hand.
B. BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to
the oor because some gas is heavier than air and will settle on the oor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s
instructions.
• If you cannot reach your gas supplier, call the re department.
C. Use only your hand to turn the gas shuto󰀨 valve. Never use tools. If the valve will not turn by
hand, don’t try to repair it, call a qualied service technician. Force or attempted repair may result
in a re or explosion.
D. Do not use this appliance if any part has been under water. Immediately contact a qualied
installer or service agency to replace a ooded water heater. Do not attempt to repair the unit! It
must be replaced!
1. STOP! Read the safety information above on this label.
2. Turn o󰀨 all electric power to the appliance.
3. Do not attempt to light the burner by hand.
4. Turn the gas shuto󰀨 valve located on the outside of the unit to the closed position.
5. Wait ve (5) minutes to clear out any gas. If you then smell gas, STOP! Follow “B” in the
safety information above on this label. If you don’t smell gas, go to the next step.
6. Turn the gas shuto󰀨 valve located on the outside of the unit to the open position.
7. Turn on all electrical power to the appliance.
8. If the appliance will not operate, follow the instructions in “To Turn O󰀨 Gas to Appliance,” and
call your service technician or gas supplier.
1. Turn o󰀨 all electric power to the appliance if service is to be performed.
2. Turn the gas shuto󰀨 valve located on the outside of the unit to the closed position.
FOR YOUR SAFETY READ BEFORE OPERATING
OPERATING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE