Installation Guide
22 Page
TEMPERATURE REMOTE CONTROLLER
-Oponal item-
temperature adjustment without having to go to the heater.
When installed, the remote will take priority over the built-in controller.
Verify that the items listed below are included with the remote controller 100209924 (TM-RE42).
Temperature
remote controller
Screws Fork terminals Manual
Qty: 1
Qty: 2
Qty: 4
Qty: 1
-Installaon-
This remote controller is NOT waterproof.
The water heater can only have one remote controller.
Do not install in high temperature environments, high humidity conditions outdoors,
in direct sunlight, or within the reach of children.
Make sure the remote controller does not come into contact with water or oil.
WARNING
Do not place the remote controller cable close to other wires from other products.
Cables used for the remote controller connection must be:
Minimum 20 gauge wire (No polarity)
Maximum 400 ft (122 m) long
NOTICE
<Mounting and wiring the remote controller>
1.
Take off the Back plate from the remote controller with a flat head screwdriver. (Fig. A and B)
2.
Attach the Back plate on the wall with the two provided screws. (Fig. B)
Fig. B
Back plate
3-1/4 inches
(82.6 mm)
Attach the screws
Cut out the partition with pliers
Main body
Fig. A
Main body
Twist
Press and twist flat head
screwdriver against the cutout.
Installaon
Installaon Manual