Installation Guide

APPENDIX
APPENDIX: HORIZONTAL MOUNTING OF POU MODELS
As stated on page 12, point-of-
use (POU) models may be mounted
horizontally. Note the following:
horizontally, it must be mounted
with brackets (provided). The
nipples must face toward the right
as shown in Figure 27.
models cannot be mounted
horizontally. They must be mounted
vertically (nipples facing upward).
12.
NOTICE:
(Figure 2, page 11) before you start.
1
Complete the installa on
steps on pages 11 and
12. Stop when you have
completed step 7 on page 12.
2
Secure both brackets to the
wall. (See Figure 28.) Use
screws, bolts, or anchors as
appropriate. NOTE: To drill pilot holes
for the #10 screws that are provided,
Ensure that the mounting surface and
fasteners will support the weight of
the water heater.
Continued on the next page.
Mount the brackets to the
surface as shown.
See Figure 29 for fastener
loca ons.
Figure 28.
11.22 inches
(11 )
4.31 inches
(4 )
Pilot hole center distances:
Figure 29.
Horizontally-mounted POU water heater:
Figure 27.