Operating Instructions and Installation Instructions

17
3 ASSEMBLY AND INSTALLATION [INSTALLER]
The station is ready to be mounted to the wall.
1. Remove the front shell of the insulation.
2. Copy the mounting holes to the mounting
surface.
3. Fasten the solar pump station to the wall with
the enclosed dowels and screws.
4. Connect the solar pump station to the system
by pipe work:
1
Supply collector eld
2
Safety group: expansion tank
3
Return collector eld
(from heat exchanger)
Not included in the scope of delivery!
5. Connect the connecting pipeline for the
expansion tank below the safety valve and x
the bracket for the expansion tank.
6. Set the initial pressure of the expansion tank
to the system and connect the expansion
tank.
7. Tighten all union nuts and screw connections.
The mounting of the solar pump station is
nished. Connect the pump and the sensors
according to the controller manual and put
the station into operation.
The mounting of the solar pump station is
nished. Connect the pump and the sensors
according to the controller manual and put the
station into operation.