Instruction manual

-Page 14 –
© A.W. Communication Systems Limited 2004
establish the channel connect. The display then returns to the Set radio channels sub-
menu and the user has the choice to scroll to another menu option, or press [CLEAR]
to move back up the menu system.
Setting the DRC-32 Channel Presentation
The DRC-32 has the capacity to allow the user an option of monitoring and selecting
up to seven radio channels on the DS-32 switch. The pre-selected channels are
presented under the CH1 to CH7 buttons. The user can pre-select which switch
channels are used on his DRC-32 from the console channel menu option. To change
the channel pre-selection, press [MENU] to access the menu system. Use the [↓] key
to move down the menu until the top line of the display is “Set Radio Channel”, press
[MENU] again to select this item. Use the [↓] key to move down the menu until the
top line of the display is “Console channel 1-7”, press [MENU] again to select this
item. The display now shows the channel buttons 1 to 7 along the top row and the pre-
selected switch channel number associated with the channel button along the bottom
row of the display. To change or add a pre-selected channel, press the numeric key
appropriate for the channel (i.e. key 3 for channel 3). The top row of the display now
shows the message “console chan 3 radio port” and the selected port number. Enter a
new port number from the numeric keys and press [MENU] to pre-select the channel.
The display now returns to the channel selection sub menu allowing the user to select
another channel button or press [CLEAR] to move back up the menu system.
Setting the Default console Channel
Upon start up the DRC-32 can automatically select a preferred operating channel; this
is especially useful when there is only one channel available to operators on the DS-
32 switch. To set the default switch on channel, press [MENU] to access the menu
system. Use the [↓] key to move down the menu until the top line of the display is
“Set Radio Channel”, press [MENU] again to select this item. Use the [↓] key to
move down the menu until the top line of the display is “Default tx chan 1-7”, press
[MENU] again to select this item. The display now shows “Default console TX” press
the numeric key for the channel you require as a default then press [MENU] to select
the item. The display then returns to the Set Radio channel sub menu allowing the
user to scroll to another item or press [CLEAR] to move back up the menu system.
Volume Adjustment - Headset
Press [MENU] to access the menu system. Use the [↓] key to move down the menu
until the top line of the display is “Headset volume”, press [MENU] again to select
this item. The display now changes to indicate the current volume setting as both a
bar-graph and number. Use [VOL UP] and [VOL DN] to adjust volume level. When
the desired volume is set, press [MENU] to store the value. The display returns to the
top level menu and the user has the choice to scroll to another menu option, or press
[CLEAR] to leave the menu system.