User guide

Page 12 of 34

Switching between Monitor and Select

If an operator wishes to toggle between monitor and select modes on a channel, all they

have to do is click upon the channel button and the coloured band will indicate the new

state.

Note that if single channel select mode has been set up in the configuration, when an

operator selects a second channel by clicking on the channel button, any channel previously

selected will revert to the monitor state.

Setting the channel to OFF

If the operator wishes to turn the audio for a particular channel off, they will need to set the

channel to the monitor mode and then click and hold down the channel button for two

seconds. The coloured bar at the bottom of the channel button will then revert to grey,

indicating that the channel is available but all audio is muted.

Function Indicators

Each channel button has several function indicators, which can show the status of the

channel attributes.

The indicators show the following information: -

T/T Indicates that the channel has talk through enabled

SQL Indicates that the channel has the squelch defeat enabled

SEL Indicates that another operator has the channel selected

Con Indicates that the channel is cross-connected (patch)