Instructions for Use

• The batteries are subject to internal chemical reactions during charge and discharge, which modify their internal temperature. It is possible to
choose a maximum temperature value which, once reached, will stop automatically any charge / discharge / balance process. A temperature
sensor is provided with the charger and can be plugged on the left side of the charger ( Temp. Sensor).
• A safety timer can be set up in order to reduce accident risks. This does not affect the fact that the user must be close to the charger during any
process.
• In order to protect the input energy source (car battery for example), the input voltage is checked at all time by the charger. If the voltage
should rise or drop out of the charger normal operation voltage limits, any process would be immediately stopped.
• The charger has 5 user memories allowing the user to store and call back customised parameters for the batteries he often charge / discharge.
Always check that the selected program is matching the batteries connected to the charger.
• The charger software features a « cycling » function. It can proceed up to 5 cycles of charge / discharge, allowing to stimulate and balance the
batteries when needed.
• Discharge function : it’s main function is to try to get rid of the batteries “memory effect” in order to try to bring back a battery to it’s nominal
capacity. Several charge / discharge cycles are necessary for this. The charge / discharge values must match the batteries manufacturers
warnings, in order to avoid a too deep discharge or over-charge. Attention should be given to Lithium batteries which have no particular
reasons to be discharged except for long time storing. A deep discharge is fatal for a Lithium battery and can be a factor of fire or short-circuit.