User's Manual


Chapter 2 – Getting Started 12
Rugged Tablet Computer RTC-1200SK
2.2 Notes Before Use
Before using your device, please read through the following instructions
 Use only the power adapter that comes with your device. Using a different
power adapter may cause damage.
 The AC cable is designed for the RTC-1200SK only
 This product is intended to be supplied by a Listed Power Adapter or DC
power source, rated 12Vdc, 3A minimum, Tma = 40°C. Please contact
AAEON for further assistance.
 Using a power outlet is the best way to charge your device (refer to section
1.2 for the adapter’s voltage output and acceptable input)
 When using the device for the first time, fully charge the battery for up to 8
hours. If the device is inactive, charging the battery once per month is
recommended to prevent deterioration.
 There are two batteries in the RTC-1200SK: both batteries can be
monitored at the title bar). Charge the device once battery 1 drops below
20%
 Always allow your battery to be fully charged before use. Calibrating the
battery before use is also highly recommended.
 To prolong battery life, allow a fully charged battery to discharge more than
95% before recharging
 Ensure that the battery cover is properly secured by manually pushing the
pin to lock position.
 The RTC-1200SK CANNOT be charged via an USB connection.
 The IP65 waterproof protection may get damaged when subjected to
shocks greater than levels tested in MIL-STD-810G Method 516.6
Procedure IV. The protection may also be affected if the rubber connector
fails to cover or close firmly.