Owner manual

Embedded Controller AEC-6612
Chapter 2 Hardware Installation
2 - 5
2.3 List of Jumpers
The board has a number of jumpers that allow you to configure your
system to suit your application.
The table below shows the function of each of the board's jumpers:
Label Function
JP1 Touch Screen 4/5/8-wire Mode Selection
JP2 AT/ATX Power Mode Selection
JP3 COM2 RI/+5/+12V Selection
JP4 Clear CMOS
JP5 LVDS Inverter/ Backlight Bias/PWM Mode Selection
JP6 LVDS Operating Voltage Selection
JP7 LVDS Inverter/ Backlight Voltage Selection