Instruction Manual

Embedded Controller AEC-6613
Chapter 2 Hardware Installation 2 - 8
2.3 List of Jumpers
The board has a number of jumpers that allow you to configure your
system to suit your application.
The table below shows the function of each of the board's jumpers:
Label Function
JP1 Auto Power Button Selection
JP2 Clear CMOS
JP3 COM2 RI/+5/+12V Selection
JP4 Touch Screen 4/5/8-wires Mode Selection
JP5 Brightness Control for 2nd LVDS
JP6 2nd LVDS Backlight Bias/PWM Mode Selection
JP7 2nd LVDS Operating Voltage Selection
JP8 2nd LVDS Inverter Voltage Selection
JP9 1st LVDS Inverter Voltage Selection
JP10 1st LVDS Backlight Bias/PWM Mode Selection
JP11 1st LVDS Operating Voltage Selection