Owner's manual

3-7
Chapter 3: BIOS setup
Parallel Port [Enabled]
Allows you to enable or disable the parallel port (LPT/LPTE). Conguration options: [Enabled]
[Disabled]
The followins two items appear only when you set the Parallel Port to
[Enabled].
Change Settings [Auto]
Allows you to select the Parallel Port base address.
Conguration options: [Auto] [IO=378h; IRQ=7] [IO=378h; IRQ=5,7]
[IO=278h; IRQ=5,7] [IO=3BCh; IRQ=5,7]
Device Mode [STD Printer Mode]
Allows you to select the Printer Port mode.
Conguration options: [STD Printer Mode] [SPP Mode] [EPP-1.9 and SPP
Mode] [EPP-1.7 and SPP Mode] [ECP Mode] [ECP and EPP 1.9 Mode] [ECP
and EPP 1.7 Mode]
3.3.7 NCT5104DSecondSuperIOConguration
Allows you to congure the system super I/O chip parameters.
SerialPort3~6Conguration
The sub-items in this menu allow you to set the serial port conguration.
Serial Port [Enabled]
Allows you to enable or disable the serial port (COM).Conguration options:
[Enabled] [Disabled]
The followins two items appear only when you set the Serial Port to [Enabled].
Change Settings [Auto]
Allows you to select the Serial Port base address.
Conguration options: [Auto] [IO=3F8h; IRQ=10] [IO=3F8h; IRQ=10, 11]
[IO=2E8h; IRQ=10, 11] [IO=2D0h; IRQ=10, 11] [IO=2C0h; IRQ=10, 11]
3.3.8 NCT6791D HW Monitor
Allows you to monitor the hardware status.
SmartFanConguration
The sub-items in this menu allow you to set the smart fan conguration.