User Manual

Full-size SBC FSB-B75G
Chapter 2 Quick Installation Guide 2 - 7
2.6 Setting Jumpers
You configure your card to match the needs of your application by
setting jumpers. A jumper is the simplest kind of electric switch. It
consists of two metal pi ns and a small metal clip (often prote cted by
a plastic cover) that slides over the pins to connect th em. To “close”
a jumper you connect the pins with the clip.
To “open” a jumper you remove the clip. Sometimes a jumper will
have three pins, labeled 1, 2 and 3. In this case you would connect
either pins 1 and 2 or 2 and 3.
1
2
3
Op en Closed Closed 2-3
A pair of needle-nose pliers may be helpful when wo rking with
jumpers.
If you have any doubts about the best hardware configuration for
your application, contact your local di stributor or sales
representative before you make a ny ch ange.
Generally, you simply need a standard cable to make most
connections.