Owner's manual
IMBM-H61B
2-20
8. USB 2.0 connectors (10-1 pin USB56, USB78)
These connectors are for USB 2.0 ports. Connect the USB module cable
to any of these connectors, then install the module to a slot opening at the
back of the system chassis. These USB connectors comply with USB 2.0
specication that supports up to 480 Mbps connection speed.
CAUTION! Never connect a 1394 cable to the USB connectors. Doing so will
damage the motherboard!
NOTE: The USB module cable is purchased separately.
IMBM-H61B Front USB 2.0 Header connectors
+5V_USB_P78
S_USB_PN7
S_USB_PP7
GND
NC
+5V_USB_P78
S_USB_PN6
S_USB_PP6
GND
USB56
+5V_USB_P910
S_USB_PN9
S_USB_PP9
GND
NC
+5V_USB_P910
S_USB_PN8
S_USB_PP8
GND
USB78
PIN 1 PIN 1
9. SPI programming connector (8-pin SPI)
Use this connector to ash BIOS SPI ROM.
IMBM-H61A
IMBM-H61A SPI programming connector
PIN 1
SPI
(NC)
SPI_MOSI
SPI_CLK
GND
(NC)
SPI_MISO
SPI_CS#
+V3.3SPI