User Manual

IMBM-Q87A

2-22

9. USB 2.0 connector (10-1 pin USB910)

These connector are for USB 2.0 ports. Connect the USB module cable to

the connectors. These USB connectors comply with USB 2.0 specications

that supports up to 480 Mbps connection speed.

IMBM-Q87A Front USB 2.0 Header connector

+5V

USB9-

USB9+

GND

(NC)

+5V

USB10-

USB10+

GND

USB910

PIN 1

CAUTION: Never connect a 1394 cable to the USB connector. Doing so will

damage the motherboard.

NOTE: The USB module cable is purchased separately.

10. Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch.

Connect one end of the chassis intrusion sensor or switch cable to this

connector. The chassis intrusion sensor or switch sends a high-level signal to

this connector when a chassis component is removed or replaced. The signal

is then generated as a chassis intrusion event.

By default, the pin labeled “Chassis Signal” and “Ground” are shorted with

a jumper cap. Remove the jumper caps only when you intend to use the

chassis intrusion detection feature.

IMBM-Q87A Chassis intrusion connector

No Intrudor

Intrudor

PIN1

CHASSIS