User's Manual

Certified : 10801A-ISFM220X : XBD-ISFM2201
1. Introduction
Thank you for choosing the iSimple ISFM2201 as your media and hands-free integration
solution. The ISFM2201 is designed to provide the connecting link between your iPhone,
Android or Bluetooth powered device and your vehicle.
InSeam is not a simple car kit, but goes far beyond the hands-free or streaming audio by
allowing the user to fully pilot its smartphone or Tablet via Voice Recognition (VR). InSeam is
fully integrated into the vehicle steering wheel control buttons, providing a seamless
transition between radio mode and smartphone mode. InSeam allows the user to open any
application installed on the user smartphone by simply pushing a button on the steering
wheel and speak the name of the application – the commands depend on the VR application
chosen by the user.
It is now possible to hear the text messages on the car audio system, see them on the radio
display and even reply by speaking the message without touching the device. Or launch the
Navigation and hear confirmation by simply speaking the direction. InSeam has also parental
controls build in. Parents can disable notifications (email or text messages) based on speed
detection to avoid driver distraction.
For best results AAMP recommends the use of iPhone 4S and iPhone 5 and Android 3.0 and
higher devices.
2. ISFM2201 Components
• Bluetooth Module
• Microphone
• Harness
• InSeam Application (Free download from iTunes store or Android Play Store)
• CAN bus adapter module (only required for CAN enabled vehicle)
3. Installation Options
The ISFM2201 interrupts the incoming antenna signal when in use, to deliver the cleanest
audio possible from your device.
A. Connecting to any FM equipped radio
1. Red Wire. Connect to switched accessory power (not constant)
2. Yellow Wire. Connect to constant battery power
3. Black Wire. Connect to ground.
4. Microphone. Once installed, plug the connector from the microphone
into this location..
5. Antenna input. Connect antenna lead from the vehicle.
6. Antenna output. Connect antenna lead into back of radio.
Note: Antenna adaptors may be needed for select vehicles!
The ISFM2201 is compatible with amplified antenna systems, and adaptors.
B. Additional connections for vehicles with compatible
steering wheel controls