Simple iPod Interface for BMW Instruction Manual
TOP VIEW
1 2
3
4
5
6
7
8
DIP
ON
DIN CONNECTOR / DIP SWITCH VIEW
22-PIN HARNESS VIEW
1.3 Programming the iSimple BMW Interface
Now that you have identied the correct harness and dip-switch conguration us-
ing the application guide, it is now time to program the interface.
To program the interface, set the dip-switches located on the side of the interface
(see Fig.1 below) to the congguration listed below. Switches are in their default
setting of “off” in the up position and are turned “on” when switched down. Refer to
the chart on the bottom of this page.
This programs the iSimple BMW interface to the vehicle it is being installed in. The
dip-switches MUST be set before the interface is plugged into the vehicle. Otherwise
the iSimple BMW interface will not work correctly.
Dip Switch Conguration Chart
Fig.1 Side view of Interface with dip switches
2
iSimple BMW interface
Docking cable
Vehicle specic harness
BRAND
BMW
MODE
CDC or
Changer
HARNESS
Vehicle
specic
harness
1 2 3 4 5 6 7 8
OFF OFF ON ON OFF OFF OFF ON