Owner`s manual

5. Installation

1. When making electrical connections it is always recommended

that the vehicle’s battery be disconnected from the electrical sys-

tem before performing the installation.

2. Carefully remove the trim panels covering the 7mm bolts that secure

the radio into the dash cavity. Remove these bolts, and carefully pull the

radio from the dash of the vehicle. This will provide access to the factory

radio connectors where you will connect the Media Gateway harness.

3. Disconnect the factory 24-Pin harness and 16-Pin harness (if pres-

ent) from the back of the radio. Disconnect the antenna adaptor from

the radio.

4. Connect the 8-Pin iPod docking cable into the rst port on the Media

Gateway furthest away from dipswitches. Carefully run the 11 foot iPod

cable behind the dash to the location where the iPod will be mounted

or stored (for example; the glove box or center console). This location

will vary based on the vehicle, and customer’s perference. When run-

ning this cable through the dash, be sure to secure it away from moving

parts or sharp metal edges that may damage the cable.

5. If connecting the HD Radio tuner (HDRT sold separately) Plug the 3

foot HD Radio Cable (8-Pin mini-din to 8-Pin mini-din) cable into the

second port (closest to the dipswitches) on the Media Gateway. Con-

nect the other end of this cable into the HD Radio tuner. Connect the

factory antenna cable into the antenna connection on the HD Radio

tuner (HDRT) Using the supplied antenna adaptor if needed to make

this connection.

6. Plug in the male connectors on the PGHFD1 harness into the 24-pin port

and 16-pin port on the back of the radio. Next, connect the factory 24-pin

and 16-pin harness (if present) into the female connectors on the PGHFD1

harness. Be sure to make a rm connection but do not force it. Plug the black

micro-t 24-pin connector on the PGHFD1 harness into the PXAMG

Media Gateway box.

7. To complete the installation secure the Media Gateway (PXAMG) and

HD Radio tuner (HDRT) into the cavity in the dash behind the radio.

Be sure that the cables and interface modules are not near moving

parts or sharp metal edges as they may damage the cables. To prevent

rattling noises inside the dash, use zip ties, or electrical tape, or other

fasteners to mount the interfaces to the factory wiring or installed audio

components (for example under the factory Satellite tuner (if present).