C50ic C60ic C62ic C80ic owner's manual analog and digital systems
table of contents introduction cautions about this manual features installation precautions and tips general mounting suggestions prewiring preparing the wall or ceiling cutout installation preparation final installation custom painting operation specifications warranty information 1 1 1 1 2 2 3 3 3 4 4 4 5 6 introduction Thank you for purchasing an a/d/s/ in-ceiling speaker system. Please read the following instructions carefully.
may be above the ceiling. This facing is a moisture barrier. Use duct tape or wide vinyl tape to seal any cuts. Keep debris and loose material away from the installation location. Do not allow debris to get in the openings of the woofer basket. Debris and loose material can cause buzzing or rattling, and can damage the woofer cone. Install plastic or fiberglass screening above the speaker to keep debris away. Handle the speaker carefully. Do not let anything touch the speaker cone or dome.
prewiring • Check local building and electrical codes for compliance of the speaker wire. • Use stranded wire of at least 16 gauge; for runs over 100 feet, it is preferable to use 14 gauge wire. • Use only insulated staples or nylon tie straps to secure wiring within the wall to avoid shorts. • Do not stretch the wire as it is being routed. This could create future (and costly) problems. • Leave about 2-3 feet of free wire at both ends. Cutting excess wire is better than splicing.
final installation The speaker is held in place with four mounting clamps that are part of the assembly. When shipped from the factory the clamps are pivoted so they will fit into the mounting hole. When the mounting hole clamp screws are turned, the clamps pivot outward and are then drawn downward until they press against the back of the mounting surface. Insert the speaker/mounting bezel assembly into the mounting hole.
specifications C50ic C60ic C62ic C80ic (Stereo) Frequency response (Hz) 81-20kHz 57-20kHz 65-20kHz 52-20kHz impedance 8 ohm 8 ohm 8 ohm x 2 8 ohm Sensitivity 1W/1M (dB) 86dB 87dB 87dB 88dB max bezel diameter 8 1/16" 9" 9" 10 11/16" mounting hole 6 9/16" 7 3/4" 7 3/4" 9 7/16" rear clearance 2 5/8" 3 1/4" 3 1/4" 3 5/8" recommended power 20-80watts 20-80watts 20-80watts x 2 20-80watts Woofer 5 1/4" 6 1/2" 6 1/2" 8" Tweeter 3/4" dome 3/4" dome 1" dome X 2 1" dome
warranty information LIMITED FIVE YEAR CONSUMER WARRANTY FOR PRODUCT INSTALLED BY AN AUTHORIZED LICENSED DEALER Directed Electronics, Inc. promises to the original purchaser, to replace this product should it prove to be defective in workmanship or material under normal use, for a period of five years from the date of purchase from the dealer as indicated by the date code marking of the product PROVIDED the product was sold by an authorized Directed dealer.
© 2004 Directed Electronics, Inc. All rights reserved G39601.06.11.