Installation manual

Arley Wood & Multifuel Stoves 17
INSTALLATION
FIREBOX LINER PANELS
The Arley Wood and Multifuel stoves use reflective
liners to the sides and back. The throat plate sits on
top of the side and rear panels. These should come
fitted to your fire, if however they are not proceed
as follows to fit them.
•Remove the front fuel bars or multifuel grate.
•Set the small liners into the back of the fire.
•Insert side liner panels
•Fit the throat plate with the single bend and two
cut outs to the front facing up. The projecting lugs
sit on top of the side liners. The long centre tab on
the back edge rests on the rear liners. The shorter
turn-down tabs against the vertical face.
•Replace the front fuel retainer bars or multifuel
grate.
Note: Neither the rear firebox liners nor the side
firebox liners are "handed", both faces are
suitable for direct contact with the fire.
Note: Cracking of lining panels does not effect
efficiency.
Fig. 11 Arley 11 multifuel liners and baffle.
Fig. 12 Liners inserted in Arley 11 multifuel.
Fig. 13 Inserting Throat Plate in to Arley 11
multifuel.
Fig. 14 Liners, throat plate and grate in
Arley 11 multifuel.
REMOVAL OF THE THROAT PLATE
Blocked chimneys cause dangerous fumes to
escape. Remove throat plate at least monthly to
clean. Keep chimney and flue ways clear.