SIP IP Phone Administrator Guide

Operational Features
41-001160-03, Rev 00, Releaes 2.4 5-325
Configuring Operational Features
XML Action URIs
The IP phones have a feature that allows an administrator to specify a uniform
resource identifier (URI) that triggers a GET when certain events occur. The IP
phone events that support this feature are:
The IP phones have a feature that allows an administrator to specify a uniform
resource identifier (URI) that triggers a GET when certain XML events occur. The
Action URI feature prevents the phones from hanging if the Action URIs should
fail. The phones also support transparent, non-blocking, XML post execute item
URIs.
The IP phone XML events that support this feature are defined in the following
table.
Action URI Description
Startup Specifies the URI for which the phone executes a GET on
when a startup event occurs.
Successful Registration Specifies the URI for which the phone executes a GET on
when a successful registration event occurs.
Registration Event Specifies the URI for when registration events occur or when
there are registration state changes.
Note: This action URI is not called when the same event is
repeated (for example, a timeout occurs again when
registration is already in a timeout state.)
Incoming Call Specifies the URI for which the phone executes a GET on
when an incoming call event occurs.
Outgoing Call Specifies the URI for which the phone executes a GET on
when an outgoing call event occurs.
Offhook Specifies the URI for which the phone executes a GET on
when an offhook event occurs.
Onhook Specifies the URI for which the phone executes a GET on
when an onhook event occurs.
Disconnected Specifies the URI that the phone executes a GET on, when it
transitions from the incoming, outgoing, calling, or connected
state into the idle state. For more information, see “Action URI
Disconnected” on page 5-336.
Draft 1