Operation Manual

Supplementary features
58 eud-1279/1.0 – R1.0 – 12.2010
Activating personal call routing
You wan to specify which of your phone shall ring when you receive a call.
If your system administrator has set up a phone number with several phones for you
as well as the 5 call routings, you can specify which of your phones shall signal a call
by using the personal call routing. Your system administrator can set up up to 5 call
routings. You can only answer a call on phone where the call is signalled. Contact your
system administrator for more information.
You can activate a call routing for all phones. If you have not configured a call routing,
the default setting (all phones are ringing) is used as standard.
You can execute this function only with a */# procedure (see "User’s Guide */# Proce-
dures" on the Aastra document portal: www.aastra.com/docfinder).
Activating ring alone
You want to specify which of your phones shall ring acoustically when you receive a
call.
When your system administrator has set up a phone number with several phones, you
can define on which phones a call shall acoustically be signalled using ring alone.
When you have activated ring alone on a phone, the acoustic ringing tone is deacti-
vated for all other phones (). An incoming call is signalled in the display of all phones.
You can answer the call on each of your phones.
This function must be stored under a function key (see chapter "Configuring keys",
page 75).
Note:
When you have activated ring alone but deactivated the personal call routing for a phone in parallel, an
incoming call is not acoustically but only visually signalled.
In the idle state:
Press the function key for <Ring alone>.
➔Ring alone is activated/deactivated.