User manual

21/1551-ASP 113 01 Uen N2 2014-01-28 85
T
ELEPHONY SERVER SOFTWARE
6.4.1.5 Hardware Configuration
The hardware configuration function is used to give the following infor-
mation relevant to device boards:
• Hardware position
• Board type
• Controlling program unit (if the board is initiated)
• Pointer to the controlling program unit
• Number of hardware individuals on the board (for example, number
of supported extensions)
• Whether or not the board is blocked
There are two types of device boards: physical and virtual. The hardware
configuration function is valid for both physical and virtual device boards.
MX-ONE Classic and Lite have both physical and virtual device boards.
On request, non-initiated hardware individuals on device boards of a
certain board type can be obtained, or the selected hardware individual
can be translated to a hardware position by the system. The hardware
position can, in the same way, be translated to a selected individual.
On request, general media gateway information, such as revision infor-
mation, can be obtained. There is also a possibility to set or get informa-
tion about a certain resource in the gateway. Examples of resources are
virtual device boards, auxiliary devices, as well as the gateway itself.
6.4.2 System Configuration Change
The purpose of the system configuration change function is to adapt the
system to the actual requirements of the customer and the environment.
It is possible to reconfigure the following objects in the system:
• Physical units
– MX-ONE Telephony System — Telephony Server (for
example adding a new server to an existing system)
– MX-ONE — Media Classic
– MX-ONE — Media Lite
– MX-ONE — Media Slim
– MX-ONE — Media Server
– MX-ONE Telephony System — EMG
• Logical units
– Program unit