Owner`s manual

2 www.UsePhoenix.com • [e-mail]-Free 1-800-533-7533
1 Specifications
Part No. 4029970
Power 110-120 Vac, 7.2 amps
Water 135 pints/day @ AHAM (80°F, 60%)
Removal
Refrigerant 2 lbs. 2 oz. R410a
Charge
Blower 380 CFM
Internal Condensate Pump with 20’ lift,
30’ vinyl hose
Operating 33°F to 125°F
Range
Filters 16” x 20” x 2” Pleated Media MERV-11
Duct Intake – 12” Flex-Duct
Options Exhaust – 10” Lay-Flat
Warranty Five years;
First year 100% of Parts and Labor
Second-fifth year 100% of Parts of sealed
refrigeration system.
Dimensions Width 20”, Height 40”, Depth 23”
Weight 130 lbs.
2 Operation
2.1 Transporting the Phoenix 200HT
The Phoenix 200HT must always be upright when
transported by vehicle. It may be tipped on to its handle
and back for loading and moving by hand.
2.2 Location
Note the following precautions when locating the Phoenix
200HT:
• It is designed to be used INDOORS ONLY.
• If used in a wet area, plug it into a GROUND FAULT
INTERRUPTER.
• DO NOT use the Phoenix 200HT as a bench or table.
• It must always be used in the upright position.
• The air inlet on top & the side outlet must be at least
1 foot from walls and other obstructions to air flow.
Table of Contents
Introduction ................................................................1
1. Specifications ........................................................2
2. Operation .............................................................2
2.1 Transporting the Phoenix 200HT .......................2
2.2 Location .........................................................2
2.3 Electrical Requirements ...................................3
2.4 Condensate Removal .......................................3
2.5 Ducting ...........................................................3
2.6 Power Button ..................................................3
2.7 Pump Purge Button..........................................3
2.8 Hour Meter .....................................................3
2.9 Hours Button ..................................................3
2.10 Defrost Light .................................................3
2.11 Low Pressure Protection ................................3
2.12 Defrost Cycle ................................................3
2.13 Temperature Specific Operation ......................4
3. Maintenance .........................................................4
3.1 Air Filter ..........................................................4
3.2 Storage ..........................................................4
4. Service .................................................................4
4.1 Technical Description .......................................4
4.2 Troubleshooting ...............................................5
4.3 Air Mover Replacement ....................................5
4.4 Thermistor Replacement ..................................5
4.5 Condensate Pump Replacement .......................6
4.6 Refrigerant Charging ........................................6
4.7 Compressor/Capacitor Replacement ................6
4.8 Gravity Drain Option .........................................6
5. Wiring Diagram .....................................................7
6. Service Parts List ..................................................8
7. Warranty .............................................................10
Serial No. ___________________________
Purchase Date ______/______/_____
Dealer’s Name ___________________________________
Read the operation and maintenance instructions
carefully before using this unit. Proper adherence to these
instructions is essential to obtain maximum benefit from
your Phoenix 200HT dehumidifier.
• It is designed to be used INDOORS ONLY.
• If used in a wet area, plug it into a GROUND FAULT
INTERRUPTER.
• DO NOT use the Phoenix 200HT as a bench or table.
• It must always be used in the upright position.
www.sylvane.com
1 [phone]