Administrator Guides EN Owner's manual

Global Contacts
41-001391-00 Rev 03 – 04.2012 5-22
g) On BAS Y, Services :: Clustering :: Inbound BAS Connections the status of BAS X changes to (Registered, Con-
nected).
5. Enable Global Address Book Viewing on BAS Y. This will allow BAS X to obtain contacts from BAS Y. It will also allow
BluStar 8000i terminals on BAS Y to show the contents of BAS Y GAB:
a) If BAS Y has a fresh install (not upgrade), then on BAS Y Users :: Global Contacts :: Global Contact Editor, you
should see the button Enable Global Address Book Viewing.
b) If the previous step is seen, then on BAS X Users :: Global Contacts :: Global Address Book Sync, check that
(Last Sync: Never, Time Status: Remote BAS does not allow GAB Viewing).
c) On BAS Y, go to Users :: Global Contacts :: Global Contact Editor and click on Enable Global Address Book
Viewing.
6. If BAS Y does not have user accounts that BAS X can sync, create one:
a) Go to BAS Y Users :: Global Contacts :: Global Contact Editor and click Add (you can do the same step by going
to Users :: User Accounts and clicking Add but make sure that the Save in Global Address Book is checked).
7. Run the Sync on BAS X:
a) Go to BAS X Users :: Global Contacts :: Global Address Book Sync
b) Select BAS Y entry that you want to sync from and click Sync Now.
c) The values of Last Sync Time and Status should change.