Specifications

Chapter 5 -
Accessories
29
YES to validate and enter the intervalometer control screen.
The upper line of the display shows the interval set and the total
footage available in your magazine.
The lower line displays frame burst chosen and the number of frame
already taken. You can reset the frame count to zero by pressing the
DOWN key.
You are now ready to start the camera with the camera on/off
switch.
To exit the INTERVAL menu, press the BLUE key for three second.
The display will show the battery voltage followed by an" EXIT?"
message. Press YES to validate and go back to the default display.
Note: With a 172,8° shutter, each exposure is 0,24s instead of 0,25s
if you had a 180 degrees shutter.
In 16mm, a full 200 feet roll contains 8000 frames. When viewed at
24 frames per second, a roll last approx 5 minutes and 30 seconds.
The following formula gives you the actual time T1 (in seconds) the
event will be filmed in according to the interval, frame burst chosen
and the total number of frame taken.
TI= (interval + (frame burst : 2) x (total Nb of frame : frame burst)
Chapter 2 - The A-Minima Control Panel
28
The upper line shows the interval set and the total
footage available in your magazine
Press twice on the camera main on / off switch to
start the camera
Display during interval
To exit the INTERVAL menu, press the BLUE key for three seconds
Display during frame exposure
The new A-Minima software V2.32 brings variable exposure rate
extending it from 1/4 sec to 255 sec, using pre-programmed set-
tings.
Note: this new function is only available when setting the
"frame burst" at 1 frame.