Specifications

C o n n e c t o rs
The A-minima uses three connectors for power and accessory input
and output.
Following is a detailed list, location and main function of each.
The Lemo 6 connector located at the rear of the camera is the main
accessory connection of the A-minima. It provides remote on/off
control and power output as well a s a connection for accessory
such as a capping shutter.
The lemo 6 connector located at the bottom of the camera body pro-
vides remote on/off, power input and a connection for accessory
such as the Aaton A-minima Power Base.
The Lemo 5 connector located at the rear of the camera, above the
Lemo 6, is the timecode interface. It provides timecode communica-
tion in both ASCII (in and out) and SMPTE (in).
Chapter 4 - Connectors
43
1
2
3 4
5
6
1
3
4
5
6
2
1
2
3
4
5
LEMO 6
1 - Ground
2 - Can Bus -
3 - Can Bus +
4 - + Batt (12 Volts)
5 - Shutter pulse / Synch
6 - Start
LEMO 6
1 - Ground
2 - Can Bus -
3 - Can Bus +
4 - + Batt (12 Volts)
5 - Shutter pulse / Synch
6 - Start
LEMO 5
1 - Ground
2 - LTC in
3 - ASCII in / out
4 - Not connected
5 - Not connected
A-Minima Pin Attribution