User`s guide

Initializing the camera with an external device
The preferred method is by means of the OriginC+ wich inputs timecode in ASCII form. It
is also possible for the camera to receive information in SMPTE form, directly from a
SMPTE device such as a TC audio recorder.
Using the OriginC+: (please refer to the OC+ manual in order to program it)
Make sure the camera is powered. Connect the OriginC+ to the lemo5 receptacle located
at the rear of the camera, above the lemo6 receptacle.
Press * on the OriginC+ to send the timecode information. The camera display will show
the timecode and the small yellow LED located to the right of the display will start to
blink.
A-Minima - Control Panel
30
Using an external SMPTE device
Make sure the camera is powered. Connect the cable from the SMPTE output of the
timecode device to the lemo5 receptacle of the camera.
The display will show "LTC IN PROGRESS" then show the time, the small yellow LED
located to the right of the display will start to blink.
11:25:00
200 ft
11:25:00
200 ft
LTC IN
PROGRESS