User`s guide

Video Sync
When used in conjunction with the small Aaton Power Base, this option allows you to
automatically synchronize the camera to a source signal such as a computer/video
monitor. In that mode, the UP or DOWN arrows can phase the camera, programming
the relationship between the camera shutter and the source signal. After this one time
adjustment, the phase relationship remains identical every time the camera is turned on.
The video connector installed on the Aaton power base accepts a video composite, sinus
wave or square wave 2 ppf signal.
The video sync menu simply allows you to film a monitor or computer screen with the roll
bar ajusted just out of view.
Listed after the camera timecode options, press YES to set the camera in video sync
mode. Without a magazine installed, run the camera. Look through the camera
viewfinder at the monitor screen and press the UP or DOWN arrows until the bar is out of
view. Stop the camera and then install a magazine. The relationship between the camera
shutter and monitor remains identical.
Note: If the source signal is faulty, the camera will run at 1fps, the camera display
showing a "NO TV SYNC" message.
A-Minima - Control Panel
32
24.000
200 ft
VIDEO
SYNC