Replacement Part List

maintain the snow thrower.
After Each Use

Check for any loose or damaged parts.

Tighten any loose fasteners.

Check and maintain the auger.

Check controls to make sure they are functioning properly.

If any parts are worn or damaged, replace immediately.
All adjustments in the Maintenance section of this manual should be checked at least once each
season.
How To Remove The Top Cover (Figure 4)
1. Remove the four screws (1) from the top cover (2).
2. Remove the top cover (2).
3. To install the top cover (2), reverse the above steps.
How To Adjust The Chute Crank
If the chute crank will not rotate fully to the left or right, adjust as follows.
1. (Figure 3) Rotate the chute with the handle (1)
How To Adjust The Auger Control Cable
The auger control cable is adjusted at the factory. During normal use, the auger control cable can
become stretched and the auger drive lever will not properly engage or disengage the auger.
1. (Figure 5) Remove the “Z” hook (1) from the auger drive lever (2).
2. (Figure 6)Slide the cable boot (3) off the cable adjustment bracket (4).
3. Push the bottom of the auger control cable (5) through the cable adjustment bracket (4) until
the “Z” hook (6) can be removed.
4. Remove the “Z” hook (6) from the cable adjustment bracket (4). Move the “Z” hook (6) down
to the next adjustment hole.
5. Pull the auger control cable (5) up through the cable adjustment bracket (4).
6. Put the cable boot (3) over the cable adjustment bracket (4).
7. (Figure 5)Install the “Z” hook (1) to the auger driver lever (2).
8. To check the adjustment, start the snow thrower. Make sure the auger does not rotate when
the auger drive lever is released.
How To Remove The Belt Cover (Figure 7)
1. The belt cover (1) is fastened with five screws (2). Remove all five screws
2. Remove the belt cover (1).
3. To install the belt cover (1), reverse the above steps.
How To Replace The Drive Belt
The drive belt is of special construction and must be replaced with original factory replacement
belt available from your nearest authorize service center.
1. Remove the belt cove. See “ How To Remove The Belt Cover”.
2. (Figure 9)Remove the drive belt (1) from the idler pulley (2).
3. Remove the drive belt (1) from the engine pulley (3). Be careful, not to bend the belt
guides(4)
4. Remove the drive belt (1) from the auger pulley (5).
5. Remove the old drive belt (1).
6. To install the new drive belt (1), reverse the above steps.