User's Manual

CIR315C – User Manual
[e-mail]
Version 0.00.03
www.abcircle.com
Page 7 of 7
Compliance/ Certifications
Standards/ Systems ISO/IEC14443, ISO/IEC18092, ISO/IEC15693,
ISO/IEC7816 (SAM slot), USB 2.0 Full Speed, CCID,
Microsoft® WHQL
Regulatory/ Environmental EN62368, CE, FCC, VCCI, MIC, RoHS3, REACH
Operational Environment
Supported Operating Systems Windows® 7 and above, Linux®, Mac OS® 10.12 and
above, Android™ 6.0 and above
Ordering Information
Produce Code CIR315C-01: USB Type A Connector,
CIR315C-02: USB Type C Connector (Optional)
Warning:
 Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user authority
to operate the equipment.
NOTE: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the
user authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. The End user must follow
the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.