User manual

Software upgrade
It is very important to upgrade your software regularly when using any linux based device. It
brings a lot of new advanced functions or correction of possible errors. That is why we
recommendalways doing software upgrade always when any problems or errors occurs!
There are several ways how to upgrade software of your AB IPBox 9xxxHD:
Model RS232
Flashtools
USBklient
Flashtools
USBHost
USBkey
Network
update

ABIPBox9000HD onlyuboot YES YES fromr9207 
ABIPBox900HD onlyuboot NO YES fromr9207 
ABIPBox910HD onlyuboot NO YES fromr9207 
ABIPBox91HD NO NO YES fromr9207

AB IPBox 9xxx receivers enable doing some service settings by pressing combination
of specific buttons on the front panel of your receiver.

ThesefunctionsareavailableonolderABIPBox9000HDreceiversjustafterinstallinguboot1.3.1ornewer‐
allnewreceiversarealreadyequippedwithit.ABIPBox900HDa910HDreceiversstandardlycontains
preinstalleduboot.
1. Software upgrade through flash USB memory device (host):
‐ Backup all data saved on your USB memory device and after it erase all data.
‐ Copy an image software (any of usb_all, usb_all_noboot…..) from your PC into USB
flash memory and rename it into usb_update.img .
‐ Use “Safety remove USB device” function before disconnecting your USB flash
memory.
‐ Turn off your receiver (
+ ) and connect USB memory to USB (host)
connector on your receiver.
‐ Press and hold Standby (
) on front panel until “BOOTING” message appears on
display. Press Up button (
). “USB UPGRADE” message shoul appear on display
of your receiver – the software update performs automatically.
‐ Wait until DONE message appears and restart your receiver.
Warning: Do not turn off or operate your receiver during software upgrade !!!
2. Hard turn off
‐ Simultaneously press Standby and OK buttons (
+ ).
3. Video output setting :
‐ Press Standby (
) button on front panel and hold ( ) button on at the same
time.
‐ Actual preset video output appears on display. Use UP/DOWN cursor button to
change Video output. Confirm by pressing (
).
4. Software update through serial port (just uboot on 900/910)