Manual
Table Of Contents
- 1 General Description
- 1.1 Technical Specifications
- 1.2 General Information
- 2 Physical Organization
- 2.1 Module and Assembly Location
- 2.2 Power Supply
- 3 System description
- 3.1 Overview
- 3.2 Physical Description
- 3.3 Monitors
- 3.4 Transmitters / Modulators
- 3.5 TX Control
- 3.6 Remote Monitoring (RMS) Unit
- 3.7 Remote Control Unit
- 3.8 Remote Slave Panel
- 3.9 Remote Maintenance Monitoring (RMM)
- 4 Electrical Installation
- 4.1 Connection Overview
- 4.2 Power and Battery
- 4.3 RF Inputs
- 4.4 RF Outputs
- 4.5 DC Loop
- 4.6 Remote Control
- 4.7 PC and Modem
- 4.8 DME
- 4.9 Analog Inputs
- 4.10 Digital Inputs and Outputs
- 4.11 Battery Warning
- 4.12 Remote control connections
- 4.13 Remote slave connection
- 4.14 Interlock switch connection
PHYSICAL ORGANIZATION
NORMARC 7033
2-9
©1999 Navia Aviation AS
INSTRUMENT LANDING SYSTEM
GENERAL DESCRIPTION
Figure 2-2 shows the same section from a rear view, while Figure 2-3 shows the top half of the
wall-mounted section.
In addition, the Remote Control Assembly RCA1240C/D and Remote Slave SF 1344A are
installed in the technical control room and the control tower, respectively.
2.2 Power Supply
An External Power Supply, operating at 230V/120V mains input and providing 27V at 20A, is
normally supplied with the equipment. In special cases, a second external power supply is
supplied.
Figure2-1 NM 7033 Module Location - Front view.
11
PS 1227A
TCA 1218A
HBK 536-1
MF 1219A
OS1221B
LF1223A
RMA1215A
GPA1232A
GPA1231A
COA1207C
MO1212A