Manual
Table Of Contents
- 1 General Description
- 1.1 Technical Specifications
- 1.2 General Information
- 2 Physical Organization
- 2.1 Module and Assembly Location
- 2.2 Power Supply
- 3 System description
- 3.1 Overview
- 3.2 Physical Description
- 3.3 Monitors
- 3.4 Transmitters / Modulators
- 3.5 TX Control
- 3.6 Remote Monitoring (RMS) Unit
- 3.7 Remote Control Unit
- 3.8 Remote Slave Panel
- 3.9 Remote Maintenance Monitoring (RMM)
- 4 Electrical Installation
- 4.1 Connection Overview
- 4.2 Power and Battery
- 4.3 RF Inputs
- 4.4 RF Outputs
- 4.5 DC Loop
- 4.6 Remote Control
- 4.7 PC and Modem
- 4.8 DME
- 4.9 Analog Inputs
- 4.10 Digital Inputs and Outputs
- 4.11 Battery Warning
- 4.12 Remote control connections
- 4.13 Remote slave connection
- 4.14 Interlock switch connection
ELECTRICAL INSTALLATION
NORMARC 7033
4-23
©1999 Navia Aviation AS
INSTRUMENT LANDING SYSTEM
GENERAL DESCRIPTION
4.7 PC and Modem
PC terminals and modems are connected to the standard pin out RS232, 9 pins DSUB con-
nectors on the Connection Interface board CI1210A as illustrated in Figure 4-7
Recommended connections are:
• LOCAL - the PC located at the ILS main cabinet site.
• REMOTE 1 - the PC located at the airport technical maintenance site.
• REMOTE 2 - distant PC terminals connected through a modem.
Figure4-7 PC and modem connections.
TEMP
INDOOR
TEMP
OUTDOOR
AC
LEVEL
ANALOG
CH.1
ANALOG
CH.2
ANALOG
CH.3
DIGITAL
PORT A
DIGITAL
PORT B
DIGITAL
PORT C
DIGITAL
PORT D
TO MB1203
RS232 RS232 RS232
REMOTE
CONTROL
DC-LOOP DC-LOOP DME
LOCAL REMOTE 2 REMOTE 1 CH.1&2 CH.3&4
CI1210A
1
5
6
9
1 - CD (REMOTE 2 only)
2 - RXD
3 - TXD
4 - DTR (REMOTE 2 only)
5 - GND
6 - DSR (REMOTE 2 only)
7 - RTS
8 - CTS
9 - Not connected
BATTERY
WARNING
HBK581-1
RADIO LINK