Cut Sheet

Descriptive bulletin | FT Flexitest family 5
2.6. FT-19RS assemblies consist of up to two FT-1 switches,
two FT-14 switches, or the combination of one FT-1 and one
FT-14 switch mounted on a 19” wide, and two-rack unit (2RU),
three-rack unit (3RU), or four-rack unit (4RU) high panel suitable
for rack or switchboard mounting. Any combination of FT-1 or
FT-14 switches styles may be selected with individual black or
clear covers. Non-ABB equipment is not included with the as-
sembly
(see circle in picture 9 below).
2.7. FT-22RS assemblies consists of up to three FT-1 or two FT-
14 switches mounted on a 22” wide, two-rack unit (2RU), three-
rack unit (3RU), or four-rack unit (4RU) high mounting panel
suitable for rack or switchboard mounting. Any combination of
FT-1 or FT-14 switches styles may be selected with individual
black or clear covers.
Mounting panels for these assemblies may be of steel or alu-
minum. Steel panels are commonly available in gray, beige and
black; although panel color or finish, as well as panel height,
can be customized to meet the user’s necessities. The three
rack unit (3RU) assembly also allows switches to be positioned
off-center, in either low or high upper mounting positions in the
rack panel, allowing room for special label requirements, as
shown on page 5, figure 7.
6
9
7
10
8
6 FT-19 3RU lockable version | 7 FT-19R 3RU with Full Length Clear Cover. Switches mounted in the lower position, with special customer labels | 8 FT-19RX
3RU with Full Length Clear Cover | 9 FT-19RS | 10 FT-22RS