User's Manual

Chapter 1 
Tropos Mobile Mesh Router Installation Guide Models 4310-XA and 4319-XA 11
Connect the CPE
Connect the Ethernet CPE to the DATA connector:
4-pole, circular M-12 D-coded female
The installer is responsible for providing the Ethernet cable and connector.
Figure 5 and Table 4 show the wiring for the DATA connector.
<<Updated figure needed>>
FIGURE 5 Pin Assignments for the DC Power Connector
Connect the Antenna
Connect the antenna to the N-type connector on the router. Either connect an antenna directly to
the N-connector (requires that the router be mounted outside of the vehicle) or use low-loss
coaxial cable to connect the router to an antenna mounted outside of the vehicle. Always use the
shortest length of cable possible. Always mount the antenna in a vertical orientation.
TABLE 4 Pin Assignments for CPE
Pin
Function
1TX Data +
2RX Data +
3TX Data -
4RX Data -