User's Manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- 1 Installing the Router
- 2 Power Consumption
- 3 Product Specifications
- 4 Antenna Information
- 5 Installation Accessories
- 6 Wind Loading Considerations
- Index
Connecting Data Cables
Tropos MetroMesh Routers Installation Guide, Models 6310 and 6320 19
Attention
Une tension continue peut être présente sur les broches RJ-45 4, 5 (+) et 7, 8 (-).
Note
This is not a mid-span powered device. Never attempt to daisy-chain Power Over Ethernet devices.
Connecting the Ethernet cable
1. Have the Ethernet data cable, nut, rubber boots, and cable gland available.
2. Remove the cable gland from the bottom of the router. For power and wired network
connectivity, use the LAN port, which is farther from the edge of the router than the MGT
port (see Figure 11).
3. Press the tab on the RJ45 connector down as you push the cable through the nut. Make sure
that the orientation is consistent with Figure 10.
4. Separate the rubber boot as needed and slide the connector through the boot. Use the boot
with the smaller diameter opening, unless the cable is too wide to permit the boot to close
completely.
5. Slide the cable through the cable gland, as shown in Figure 10.
Figure 10 Routing the Data/Power Cable to the Router
trpo_014
Nut
Cable gland
Rubber boot