Installation Manual

10 ACS550-PD 3R Irrigation Packaged Drive
Suitable Mounting Location
Forselectingasuitablemountinglocationforcongurations,referto:
• PreparingforinstallationintheACS550-U1User’sManual,and
• TheTechnicalDatasectionofthismanualforinformationondimensionsand
weights.
Installing the Drive (Supplement to ACS550-U1 User’s Manual)
WARNING!
Metal shavings or debris in the enclosure can damage electrical equipment and
create a hazardous condition. Where parts, such as conduit plates require
cutting or drilling, rst remove the part. If that is not practical, cover nearby
electrical components to protect them from all shavings or debris.
Do not connect or disconnect input or output power wiring, or control wires,
when power is applied.
Never connect line voltage to drive output Terminals T1, T2, and T3.
Do not make any voltage tolerance tests (Hi Pot or Megger) on any part of the
unit. Disconnect motor wires before taking any measurements in the motor or
motor wires.
Make sure that power factor correction capacitors are not connected between
the drive and the motor.
Prepare the Mounting Location
TheACS550shouldonlybemountedwherealloftherequirementsdenedin“Preparing
forInstallation”aremet.
Mount the Drive
1. Useahoisttomovethecabinetintoposition.
Note! If the cabinet location does not provide access to the cabinet sides, be
sure to re-mount side panels before positioning cabinet.
2. Installandtightenmountingbolts.
