Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Recycling and scrapping
- 3 Safety Instructions
- 4 Important instructions
- 5 Get started
- 6 Installing DAU
- 7 Installation of Accelerometers (Vibration Measurement)
- 8 Installation in Motors with Fins
- 9 Installation of Magnetic Field Sensor (MFS)
- 10 Configuration
- 11 Terms for using ABB MACHsense-R – MSR1600 product/service
Document type Document identity Revision Page(s)
Instruction manual for MACHsense-R - MSR1600 1MZB100400 A 13(31)
We reserve all rights in this document and in the information contained therein. Reproduction, use or disclosure to third parties without
express authority is strictly forbidden.
© Copyright 2017 ABB PROPRIETARY AND SECRET INFORMATION
5.3 Preparations for installation
5.3.1 General
Adequate planning and preparation results in correct installation, assures safe running conditions and
maximum accessibility.
During installation, general as well as local safety instructions must be followed.
5.3.2 Power supply
· MACHsense-R requires external power supply 110-240 V AC
· Recommended fuse is 10 A
· Recommended cable area is 1.5 mm
2
· Installation should be made by certified electrician according to local regulations and applicable
standards.
5.3.3 Tools and materials
Suitable materials for set-up as well as other auxiliary tools for installation are normally not included in
the ABB delivery. Auxiliary tools for installation are to be supplied by the customer.