Installation guide

The integration process
8 LonWorks
3 Assign and download custom equipment in i-Vu CCN
1 Open i-Vu CCN.
2 In the navigation tree, right-click the area where you want to place the custom equipment. Select Add
Equipment from the drop-down menu.
3 Make the following entries:
Field
Notes
Display Name
Type an equipment name (i.e. ABB Drive).
Associate with
If your i-Vu Link is connected to CCN devices:
○ Enable CCN Device and fill in the bus and element
number of the CCN device that this custom
equipment will be linked to.
NOTE
This "association" is what allows you to use the
term "link" in CCN address strings for this custom
equipment rather than manually typing in the bus,
element number into each CCN address string.
If your i-Vu Open Link is NOT connected to CCN devices
(only LonWorks devices):
○ Enable CCN Link and pick the i-Vu Link that is
physically connected to the LonWorks network.
Equipment
Click
Add.
Browse to the .equipment file that was generated in
ApplicationBuilder.
Click
Continue
.
When message appears "File uploaded successfully",
click
Close
.
4 If you have already created a custom equipment graphic for this third party device in ViewBuilder, you
can also add that graphic from this screen. Under
Views, click Add and browse to your .view file. Click
Continue. When message appears File added successfully, click Close. The custom equipment should
now appear in the navigation tree.
5 Click Exit Setup and the custom equipment will be downloaded to the i-Vu Link.
4 Configure LonWorks points using LonWorks Integration tool
1 Log in to i-Vu CCN.
2 In the navigation tree, right-click on the custom equipment and click Configure.
3 Navigate to the Integration Points section at the bottom of the screen and click Export.