User's Guide

DIGITAL DRY TRANSFOR MER
2019-03-19 52/57
2. Cut and strip the alarm wire and the extension wire 0.25” inch (6.5mm) then crimp the required lug
onto each wire. Bolt the alarm wire lug to the extension lug. Connect the extension wire to the alarm
relay of the Transformer line protection.
3. Repeat steps 1 and 2 with the trip wire.
12.3 Communications Pod and Ethernet Connections
The Communications Pod provides Wi-Fi communication to the TXpert system and must be attached in
an area that can be safely accessed while the transformer is energized.
Communications Module Kit List
Unit
Equipment
Item
Qty
Part ID
Part Description
1
1
1LBU100194A0002
Communications Pod
2
1
1LBU100187A XXXX
Communications Pod Cable (6-pin)
3
2
1LBU100230A0001
RFID Card
4
1
Bracket
5
HW?
6
HW?
7
1
1LBU100209A XXXX
Ethernet Cable
Table 17
The Communications Pod is shipped with a bracket, attach the bracket as required by the space. The
pod may be attached horizontally or vertically.
Route the cable from the main TXpert module to the Communications Pod and connect. A sample instal-
lation is shown below. Assuming the one end is already connected?