Reference Class Manual

1.2 Setup

CD-77 System Setup (CD-77 + AM-77 + Speaker)

The following diagram graphically illustrates the standard connection of the CD-77 in a two-channel system.

i. Unpack the CD-77 and remove the protective foam insert

from inside the CD well.

ii. Remove the protective sheet from the acrylic front panel.

iii. Ensure the CD-77 is located on a level and solid surface

capable of supporting at least 50 kgs.

iv. Using the spirit level located inside the CD well, check the

CD-77 is on a level platform

v. Connect the desired RCA/XLR interconnect via the left (blue/

white) and right (red) leads to the respective channels at the

rear of the CD-77.

vi. Connect the other end of the interconnect’s respective left

and right channels to the inputs of the amplifier. Adhere to

the correct colour-coding.

vii. Connect the IEC end of the mains power cable to the mains

receptacle of the CD-77 and connect the mains plug into a

mains socket power source.

Optional IC-77

interconnect may be

purchased sepa-

rately