Instruction Manual

Section 6 - Analogue Volume Control (AVC)

6.1 Using the Mode Switch

The DP-777 Digital Processor comes with a built-in Direct-Coupled, Buffered Analogue Volume Control system

(AVC).

This means that the DP-777 via the rear panel Mode switch (R6) may be used as:

i. Volume+: DP-777 is both a digital and analogue pre-amplifier (Analogue Inputs 6 & 7 are enabled).

ii. Volume: DP-777 is a digital pre-amplifier (Digital-to Analogue Convertor with the AVC enabled).

iii. Bypass: DP-777 is a standalone Digital-to Analogue Convertor (with the AVC bypassed).

Please note that if the DP-777 is set up to use the AVC, it will automatically switch to “Bypass” mode if the volume

is set to 0dB or “Byp” (ie: FULL volume).

Using the Analogue Volume Control System easily surpasses conventional preamplifiers in transparency, dynam-

ics and musicality.

ALWAYS POWER OFF the DP-777 via (R10) before making a different selection on the Mode switch.

Should you have any questions, please do not hesitate to contact your AMR distributor/dealer.

ALWAYS power OFF

(R10) the DP-777

before making a

Mode selection

Bypass is the default

setting