Use Manual
Table Of Contents
- Table of contents
- Read me first
- Section 1: Use or function
- Section 2: Installation procedures and special requirements
- Section 3: Principles of operation
- Section 4: Performance characteristics and specifications
- Section 5: Operating instructions
- Section 6: Operational precautions and limitations
- Section 7: Hazards
- Section 8: Service, maintenance, and diagnostics
- Section 9: Troubleshooting
- Appendix A: Alinity ci-series SAL
- Design and function
- Technical data
- Sample Access Line operation
- Buttons
- Start screen
- Power on the Sample Access Line
- Place the Sample Access Line online
- Place the Sample Access Line offline
- Pause the Sample Access Line
- Deactivate pause mode
- Restart the Sample Access Line
- Main menu screen element descriptions
- Login screen
- Access the Login screen
- Information screen element descriptions
- Access the Information screen
- Access the Configuration screen
- Error message screen
- Acknowledge an error message
- Acknowledge a message
- Weekly cleaning procedure
- Error messages
- Communication and software update error messages (0-10000)
- Module component error messages (20000-29999)
- Message code: 20105
- Message code: 20200
- Message code: 20201
- Message code: 20202
- Message code: 20203
- Message code: 20204
- Message code: 20205
- Message code: 20206
- Message code: 20207
- Message code: 20209
- Message code: 20210
- Message code: 20211
- Message code: 20901
- Message code: 20902
- Message code: 20910
- Message code: 20911
- Message code: 20912
- Archive error messages (21300-21468)
- Message code: 22501
- Message code: 22502
- Message code: 22550
- Message code: 22600
- Message code: 22601
- Message code: 22602
- Message code: 22603
- Message code: 22604
- Message code: 22605
- Message code: 22606
- Message code: 22607
- Message code: 22608
- Display error messages (23000-23017)
- Message code: 27000
- Error message on the touchscreen user interface
- CAR with sample at AccessPoint, in traffic jam, or in long queue; sample matter has been removed
- Revision history
- Index
Technical data
NOTE: Only sample tubes approved for the laboratory automation system (LAS) may be used.
NOTE: Throughput depends on the Alinity ci-series configuration and the input of samples on
the GLP systems Track.
NOTE: The safety instructions in the GLP systems Track Operations Manual must be observed.
Table 1: Technical data
Throughput 200 samples per hour for each connected Alinity ci-
series analyzer
Table 2: Environmental specifications
Altitude 30.8 m (100 ft) below sea level to 2000 m (6561 ft)
above sea level
Ambient temperature during operation 15°C to 30°C
Relative humidity during operation 30% to 80%, noncondensing
Acoustic level:
• SAL
Maximum 65 dBA
• Alinity ci-series
Comply with the manufacturer specifications.
NOTE: Electrical lines for the SAL are routed in the power ducts of the GLP systems Track. The
outlets installed in the SAL are used only for the LAS.
Table 3: Electrical safety parameters
Installation category II (overvoltage category)
Pollution degree 2
NOTE: Electrical safety parameters have no bearing
on performance.
Table 4: Energy data specifications
Supply voltage 220 V - 230 V
Supply frequency 50 Hz/60 Hz
Related information...
Alinity ci-series SAL, page 39
Appendix A
Alinity ci-series SAL
Technical data
Sample Access Line (SAL) Interface Manual
80003970-101 DRAFT - 2022-MM-DD
45