Use Manual

Input/Output Module operation
The module-specific function selection for the Input/Output Module is displayed on the main
menu. The operator selects the corresponding function and follows the instructions.
CAUTION: Damage from sharp and hard objects. Sharp and hard objects can damage
the surface of the monitor. Only use fingers or a commercially available stylus to
operate the monitor.
Related information...
Operating instructions, page 91
Power on the module (IOM), page 162
Power off the module (IOM), page 163
Place the module online (IOM), page 164
Place the module offline (IOM), page 164
Pause the module (IOM), page 165
Deactivate pause mode (IOM), page 165
Access the Login screen (IOM), page 166
Access the Information screen (IOM), page 166
Access the Configuration screen (IOM), page 167
Main menu screen (IOM), page 167
Main menu screen element descriptions (IOM), page 167
Load samples into FlexRacks (IOM), page 168
Unload samples from FlexRacks (IOM), page 170
Power on the module (IOM)
Prerequisite
• The module is connected to the power supply.
• The On/Off push button on the front of the module blinks
green.
• Front and rear module covers must be closed and locked.
Required module
status
Off for more than 1 minute
Perform this procedure to power on the module.
CAUTION: Risk of impact during module initialization.
During initialization, the drawers
on the front side of the module open and close automatically. Injuries may occur if the
distance between the operator and module is insufficient. Maintain a sufficient distance
to the module during initialization and keep the area clear of objects.
Operating instructions
Input/Output Module operation
Section 5
162
GLP systems Track Operations Manual
80003968-101 - 2021-09-16