Use Manual

Sample in CAR was exchanged, page 295
Errors at cross switch controllers, page 295
Errors at AccessPoint, page 296
Errors at charge lane, page 296
Sample is missing
Probable cause Corrective action
A sample is missing. Use the Track Sample Manager to display the last action
of the missing sample.
Related information...
Track observed problems, page 294
Operator manually loads or unloads CAR
Probable cause Corrective action
The operator removes a sample from a CAR manually or
loads a CAR manually.
CAUTION: Do not remove samples from a
CAR or the track. All samples removed from
the track must be placed back in the Input/
Output Module for appropriate routing. When
samples are removed from the track, they
must be deleted from the Track Sample
Manager before they are reloaded.
Observe that the CAR moves to the output module for
inspection purposes. Confirm that checks are performed
on the CAR loading status or on the sample.
Related information...
Track observed problems, page 294
Sample in CAR was exchanged
Probable cause Corrective action
The sample in the CAR was exchanged. Verify if there are differences in assignment between
the CAR ID and the sample. If differences in assignment
are present, the sample is transported to the error area
of the output module.
Related information...
Track observed problems, page 294
Errors at cross switch controllers
Probable cause Corrective action
Errors occurred at the cross switch controllers. Contact an Abbott Laboratories representative or an
authorized service representative.
Section 10
Troubleshooting
Observed problems
GLP systems Track Operations Manual
80003968-101 DRAFT - 2022-03-11
295
DRAFT 2022-03-11