User's Manual

Clinical Trial Support Line: 1-888-971-4766 - 38 -
ART05005 REV 4
7. Compare your Control Solution test result to the range printed on your Test Strip
vial label (see below). Your Control Solution result should fall within the range
printed on the side of your Test Strip vial. If your test result does not fall within
the range, repeat the Control Solution test with a new Test Strip.
8. Remove and discard the Test Strip. (Test Strips may be used only once.)
9. Clean the Receiver after any Control Solution test (see page 141).
You are now ready to insert the Sensor.