User's Manual

7 • Diagnostics
WHITESTAR SIGNATURE™ System Rx Only – Z370147 Rev. C 1108 7-6
Wireless Remote
Control Setup
Use the Wireless Setup button to connect the System with a Wireless Remote
Control.
Note: Make sure that the Backlight feature for the Wireless Remote Control is off
(before you start the Wireless Setup process).
Figure 7.7 – Wireless Setup Screen
1. Press Wireless Setup.
2. Select Remote Control.
3. Press Remote Pair.
4. Follow the messages shown on the screen.
5. For the Remote Control:
• Press the corresponding buttons on the wireless remote control as prompted.
If Remote Pair fails, follow the instructions on the screen.
• Press the buttons on the wireless remote control.
• Verify for each button that the corresponding button on the screen lights. If
the button does not light on the screen, the test fails. If the test fails contact
AMO for technical service.
6. Press Exit to close the window.
7. Press the Unpair button to unpair the Remote.